Chroma Color Block 2 Bedienungsanleitung PDF herunterladen (Seite 7)

Color Block 2 User Manual 6 V1.1 September 2012

www.chroma

q.com

The Color Block 2 power supplies deliver power and data via XLR4. A maximum of five daisy-chained Color Block 2 fixtures

can be connected to one cable. Return lines are not required. The total cable length of each chain must not exceed 60

meters (200ft).

It is recommended that a maximum of 20m XLR4 cable length should separate adjacent units as to avoid signal

deterioration.

Note:

Maximum of 5 Color Block 2 fixtures per cable. No return cables required.

2.3 Fixings

One of the strengths of the Color Block 2 fixture is its flexible fixing possibilities. The Color Block 2 fixture is supplied with an

integral M10 clinch nuts at each end. These can be used to attach the Color Block 2 fixture to a standard hook clamp or the

wide range of Color Block accessories listed below.

Note: Damage may occur if the bolt is too long (M10x16 maximum). In addition, both sides of the fixture feature a fixing slot

designed to accept an M6 bold head.

The Color Block 2 fixture also features an integral connection system to enable up to five units to be locked together as a

batten (see below).

Note: it is important to ensure that each fixture is also secured with a safety bond. The end plate of each fixture has a fixing

hold to facilitate secondary fixings.

a. Integrated connection system

One end of the Color Block 2 fixture features two protruding locating pins and a catch plate, the other end has two keyhole

slots and a butterfly latch.

1. To connect two fixtures together, firstly mate the two protruding pins from one fixture into the keyhole slots of the other.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Keine Kommentare

Chroma Color Block 2 Bedienungsanleitung Seite 7